Canon CLC 1120 Service Manual page 206

CHAPTER 6 IMAGE FORMATION SYSTEM
Caution:
See to it that the removed developing
assembly will remain free of foreign
matter.
Do not place the developing assembly
near the copier and handle the transfer
assembly frame or the photosensitive
drum frame unit above it.
11) Remove the black toner concentration
sensor unit.
12) Remove the screw [5], and detach the
photosensitive drum positioning roll [6].
13) Remove the three screws [7]; then, loosen
the two fixing pins [8], and slide out the
photosensitive drum frame unit [9].
Caution:
When sliding out the photosensitive
drum frame unit, be sure to work with
extra care so as not to damage the
photosensitive drum.
If contact is made near the front, lift it
slightly to remove. At this time, check
to make sure that the transfer assembly
frame unit is inside the copier.
6-54
COPYRIGHT © 1999 CANON INC.
[5]
[7] [8]
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[6]
Figure 6-604
[7] [8]
[9]
Figure 6-605
Figure 6-606
[7]