Canon CLC 1120 Service Manual page 221

8) Remove the grip ring [12], washer [13],
butting roll [14], and spacer [15].
Caution:
When assembling the part, be sure to
leave a gap of 0.2 ±0.1 mm between the
roll [4] and the washer [13].
9) Remove the E-ring [16], grip ring [17],
two gears [18], bearing [19], and sleeve
slider [20] at the rear of the developing
assembly.
Caution:
When assembling the part, be sure there
is NO gap between the gear [18] and the
grip ring [19].
10) Remove the two screws [21] at the rear of
the developing assembly, and detach the
gear cover [22].
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
[15] [14] [13]
Figure 6-640
[20] [19]
[16] [17] [18]
Figure 6-641
[22]
Figure 6-642
[12]
[21]
6-69