Editor; Removing The Editor Controller Pcb - Canon CLC 1120 Service Manual

C. Editor
1. Removing the Editor Controller
PCB
1) Remove the six face plates [1] used for
screws.
2) Remove the two screws (M8x6), six
screws (M8x10), and six screws (M8x23),
a total of 14 screws; then, detach the
copyboard cover.
3) Remove the two screws [2], and detach
the controller PCB cover [3].
4) Disconnect the two connectors [4], and
remove the 4 screws [5] and the flat cable
[6]; then, detach the editor controller
PCB[7].
COPYRIGHT © 1999 CANON INC.
CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
[1]
Figure 9-715
[2] [3]
Figure 9-716
[7]
[6]
Figure 9-717
[1]
[2]
[5]
[4]
[4]
[5]
9-23