Configuring Cef On Msfc2/Msfc3; Specifying Cef Maximum Routes - Cisco WS-C6506 Software Manual

Catalyst 6500 series switch
Hide thumbs Also See for WS-C6506:
Table of Contents

Advertisement

Configuring CEF for PFC2/PFC3A on the Switch
Destination-IP
Stat-Bytes
--------------- --------------- ----- ------ ------ ----------------- ---- ---- ----------
----------- -------- -------- --------- ---------
0.0.0.5
0
0.0.0.2
0
0.0.0.4
0
0.0.0.1
0
0.0.0.3
0
0.0.0.6
0
Console> (enable)
Enter the show mls entry cef command to display only the FIB entries. Enter the show mls entry
netflow-route command to display only the entries from the TCP intercept feature and reflexive access
control lists (ACLs). Enter the show mls entry pbr-route command to display only the PBR entries.
Enter the show mls entry qos command to display only the QoS entries.

Configuring CEF on MSFC2/MSFC3

CEF is permanently enabled on MSFC2/MSFC3. No configuration is required to support CEF for
PFC2/PFC3A.
The ip load-sharing per-packet, ip cef accounting per-prefix, and ip cef accounting non-recursive
Note
Cisco IOS CEF commands on MSFC2/MSFC3 apply only to traffic that is switched by CEF on
MSFC/MSFC3. The commands do not affect traffic that is switched by CEF for PFC2/PFC3A on the
supervisor engine.

Specifying CEF Maximum Routes

This feature is only available with Supervisor Engine 720.
Note
To specify the maximum number of routes that can be programmed in the FIB TCAM for a protocol, use
the set mls cef maximum-routes {ip | ip-multicast} routes command. The syntax is as follows:
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
13-16
Source-IP
Uptime
Age
0.0.0.5
01:03:18 01:00:51 cccccccc
0.0.0.2
01:03:21 01:00:51 cccccccc
0.0.0.4
01:03:19 01:00:51 cccccccc
0.0.0.1
01:03:25 01:00:52 cccccccc
0.0.0.3
01:03:20 01:00:52 cccccccc
0.0.0.6
01:03:18 01:00:52 cccccccc
ip—Specifies IP MLS.
ip-multicast—Specifies IP multicasting MLS.
routes—Specifies the number of routes that can be programmed in the FIB TCAM.
Prot
DstPrt SrcPrt Destination-Mac
TcpDltSeq TcpDltAck
5
204
104
cc-cc-cc-cc-cc-cc 5
cccccccc
2
201
101
cc-cc-cc-cc-cc-cc 2
cccccccc
4
203
X
cc-cc-cc-cc-cc-cc 4
cccccccc
ICMP
200
100
cc-cc-cc-cc-cc-cc 1
cccccccc
3
202
102
cc-cc-cc-cc-cc-cc 3
cccccccc
TCP
205
105
cc-cc-cc-cc-cc-cc 6
cccccccc
Chapter 13
Configuring CEF for PFC2 and PFC3A
Vlan EDst Stat-Pkts
ARPA 0
ARPA 0
ARPA 0
ARPA 0
ARPA 0
ARPA 0
OL-8978-04

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 6506Catalyst 6509Catalyst 6513

Table of Contents