The Smdr Printer And The System Programming Pc - AT&T MERLIN LEGEND Installation & Maintenance Manual

Installation
The SMDR Printer and the
System Programming PC
Both an SMDR printer and a personal computer (PC) used for
system programming can be connected to the processor
module.
Connect a Printer to the Control
Unit
A printer (AT&T models 475/476 and 572) can be connected to
the CU through the SMDR port on the processor module. There
are two procedures for installing a printer, depending on whether
the printer is within 50 feet of the CU or not.
CAUTION:
To prevent damage from electrostatic discharge (ESD),
avoid touching leads, connectors, pins, and other
components. Use a properly grounded wrist strap.
Notes:
The AT&T 570 printer is not compatible with the system
because it is not a serial printer.
Before connecting a printer, make sure that all modules have
been installed on the CU.
The printer must be plugged into the same AC outlet as
the CU.
Connect a Printer Within 50 Feet of the CU
Use the following hardware and procedure to connect a printer
to the CU when the printer is within 50 feet of the CU and is
powered from the same 117-VAC branch as the CU.
The Printer and the
PC 3-45