AT&T MERLIN LEGEND Installation & Maintenance Manual page 233

Installation
Test the Incoming and Two-Way
Dial-Repeating Tie Trunks
Follow these steps to test the dial-repeating tie trunks:
1. At a preset time, have a person at the far end place a dial-
repeating call to your
number.
Your telephone rings,
button flashes.
2. Pick up the handset.
The red LED next to the tie-trunk button goes on, and the
green LED becomes steady.
3. Verify that you have good two-way communication and hang
up.
Repeat steps 1 through 3 for each tie trunk administered.
4.
Test the Dial Access Codes
Follow these steps to test the dial access codes:
1. Verify the proper operation of each feature requiring a dial
access code:
Automatic Route Selection (ARS)
Group Calling
Group Page
Listed Directory Number (the QCC queue)
Park
Pools
Remote Access
2. If any feature is not working properly, check the system
programming translations.
telephone by dialing the proper tie-trunk
and the green LED next to the tie-trunk
System Acceptance Test 3-125