AT&T MERLIN LEGEND Installation & Maintenance Manual page 214

Installation
5. As needed, adjust the jumper settings for T/R operation or for
a supplemental alert device (see Figure 59).
a. Pull the connectors off.
b. Push the connectors down over the appropriate pins.
6. Replace the module cover.
a. If the module cover has a square jack guard that protects
the TEL/OTHER jack area, grasp and twist the guard to
remove it (see Figure 60).
Note: Save the jack guard if you are wall mounting an
MLX-10 or MLX-10D telephone.
b. There are locking tabs on both sides of the module cover
and a screwpost on the right side of the telephone. Place
the tab in the slot on the left side of the telephone.
c. Lower the cover to the right and press firmly to lock the
tabs in place. Both tabs must be secure.
d. Replace and tighten the screw you removed earlier.
7. Replace the desk stand and the user card tray.
Note: If you are wall mounting an MlX-10 or MLX-10D
telephone, do not replace the desk stand. Go to step 8.
a. The desk stand has two height adjustments. Insert the tab
at the bottom of the stand in either the low or high position.
b. Insert the tab at the top of the stand into the corres-
ponding slot on the desk telephone. To readjust the stand,
see the instructions on the bottom of the card tray.
3-106 Telephones and Consoles