AT&T MERLIN LEGEND Installation & Maintenance Manual page 234

Installation
Test the System Features
You can test these system features from an MLX telephone or an
analog multiline telephone:
Automatic Route Selection (ARS)
Coverage
Group Calling
Station Message Detail Recording (SMDR)
System Speed Dial
Note: You can also use a single-line telephone to test all of these
features except for Coverage.
ARS and SMDR Tests
If ARS patterns have been translated, you can test the routing by
placing toll calls and checking the line/trunk indicated on the
SMDR printout.
Follow these steps to verify ARS patterns:
1. Determine which toll numbers to call by examining the system
administrator's ARS patterns.
2. At any multiline telephone, pickup the handset, dial the ARS
access code, and dial one of the toll numbers. Make sure that
the call is completed before hanging up.
Repeat step 2 for any additional toll numbers.
3.
4. At the SMDR printer, verify that the call was placed over the
correct line/trunk group and check the number of seconds
before the call is reported on the SMDR printout. If there are
errors, check the translations.
3-126 System Acceptance Test