AT&T MERLIN LEGEND Installation & Maintenance Manual page 221

Installation
c. Lower the stand and press the tab(s) at the top into the
corresponding slot(s) on the telephone.
Note: The diagram on the bottom of the user card tray
also shows the steps to adjust the stand.
2. Connect the line cords (see Figure 62).
a. Plug one end of the D8W cord into the telephone jack
labeled LINE on the underside of the telephone.
b. Route the D8W cord through the cord channel on the back
of the telephone.
c. If the telephone is for desktop use, turn the desk
telephone face up and plug the D8W cord into the wall
jack.
3. Install the handset by inserting one end of the coiled H4DU
handset cord into the handset and the other end into the jack
on the side of the telephone.
Label the extension identification card (see Figure 64).
4.
a. Insert a straightened paper clip into the hole on the side of
the plastic cover while holding your finger on the opposite
edge. Use the paper clip to push and lift the cover.
b. Type or write the assigned extension number on the card.
Notes:
If you are mounting an MLX-10 or MLX-10D wall telephone,
go to step 5.
If you are assembling a desk telephone, go to step 6.
5. Prepare the handset holder for wall mounting (see Figure 64).
a. Remove the handset holder by pushing it up and pulling it
out.
b. Rotate the handset holder 180° and replace it in its slot.
Telephones and Consoles 3-113