Special Recording; Pre Rec; Clip Continuous Rec - JVC GY-HM600U Instruction Manual

Special Recording

Besides the normal recording mode, five special
recording methods are available in this camera
recorder. They are Pre Rec, Clip Continuous,
Frame Rec, Interval Rec and Variable Frame.
Select the mode from [Rec Mode] in the [Record
Set] menu.
Memo :
Set using [Main Menu] B [System] B [Record
0
Set] B [Rec Mode].
(A P106 [ Rec Mode ] )
When [Format] in the [Main Menu] B
0
[System] B [Record Set] B [Record Format]
menu is set to "AVCHD", "Clip Continuous"
cannot be selected.
(A P105 [ Format ] )

Pre Rec

By setting the number of seconds in the [Pre Rec
0
Time], you can start recording video and audio
before actual recording starts based on the [Pre
Rec Time] setting.
When starting actual recording while the camera
0
recorder is in Recording Standby (STBYP)
mode, you can start recording a few seconds
earlier based on the [Pre Rec Time] setting.
Using Pre Rec allows you to record a complete
0
event without missing the initial scenes even if
you start the recording late.
Memo :
Pre Rec Time can be set to "5sec", "10sec", or
0
"15sec" in [Main Menu] B [System] B [Record
Set] B [Rec Mode] B [Pre Rec Time].
(A P106 [ Pre Rec Time ] )
Completed Clip
(Recorded video and audio)
Recording starts a
number of seconds
earlier based on the
[Pre Rec Time] setting
Press [REC]
(Recording starts)
.
1 Set [Rec Mode] to "Pre Rec".
2 Press the [REC] button to start recording in Pre
Caution :
0
0
0
0
0
Example:
In normal recording, three clips are generated as
Recording 1, Recording 2, and Recording 3.
However, recording in this mode generates only
one clip.
Press [REC]
(Recording stops)
(A P106 [ Rec Mode ] )
Set [Main Menu] B [System] B [Record
0
Set] B [Rec Mode] to "Pre Rec".
The display changes ("STBY" B "STBYP").
0
Rec mode.
The display changes ("STBYP" B
0
"RRECP") and the card slot status indicator
lights up in red.
Press the [REC] button again to pause
0
recording. The display changes ("RRECP"
B "STBYP") and the card slot status
indicator lights up in green.
When the interval between start and stop
recording is short, "STBYP" may not be
displayed immediately after recording is
complete.
"RRECP" B "STBYP" ("STBY" blinks in red)
B "STBYP" is displayed.
When the SD card becomes full during
recording, recording stops and "STOP" is
displayed.
Video and audio before the above mentioned
time may not be recorded after recording starts
in the following cases.
Immediately after power on
0
Immediately after recording stops
0
Immediately after switching from Media
0
mode to Camera mode
Immediately after setting [Rec Mode]
0
Immediately after the end of Clip Review
0
Immediately after changing file format
0
Immediately after changing video format
0

Clip Continuous Rec

In normal recording, when the recording stops,
the image, audio, and accompanying data from
the start till the end of the recording are recorded
as one "clip" on the SD card.
This mode allows you to consolidate several
rounds of "startstop recording" into one clip.
73