Tally Lamp
The tally lamp start blinking when the remaining space on the SD card is running out during recording, or
when the battery power is running low.
Blinking Mode
Blinks slowly
(once every second)
Blinks quickly
(2 times per second)
Warning Tone
Warning tone is output from the monitor speaker and [x] terminal when the battery level is low.
0
Warning tone is also output when an error occurs in the camera recorder.
0
Memo :
You can specify whether to turn on the warning tone as well as setting the volume in [A/V Set] B [Audio
0
Set] B [Alarm Level].
(A P103 [ Alarm Level ] )
Troubleshooting
Symptom
Power does not turn on.
Unable to start recording.
Camera image is not output on
the LCD monitor and
viewfinder screen.
Playback does not start after
selecting a clip thumbnail and
pressing the Set button (R).
No sound during playback.
130
Remaining Battery Power/SD Card Space
Battery power is low
0
Remaining recording time on SD card is less than 3 minutes (during
0
recording)
Remaining recording time on SD card is zero (during recording)
0
Error on the camera recorder
0
Is the AC adapter properly connected?
0
Is the battery charged?
0
Is the power turned on immediately after it is turned off?
0
Make sure to wait for an interval of at least 5 seconds before turning
on the power again.
Is the record trigger button/lock switch on the handle turned on?
0
Is the write-protect switch of the SD card turned on?
0
Make sure that the write-protect switch is turned off.
(A P37 [Write-Protect Switch on the SD Card] )
Is the camera recorder set to the Camera mode?
0
Use the [MODE] selection button to switch to the Camera mode.
(A P16 [Operation Modes] )
Is the camera recorder set to the Camera mode?
Use the [MODE] selection button to switch to the Camera mode.
(A P16 [Operation Modes] )
Is the selected clip a playable clip?
Playback is not possible if the clip has a different video format setting.
Is the currently played clip recorded in the Variable Frame Rec mode?
(A P77 [Variable Frame Rec] )
Action