Audio Recording - JVC GY-HM600U Instruction Manual

Audio Recording

You can record audio from the two channels (CH1/
CH2) in synchronization with video images on this
camera recorder.
Select from the four options below to record the
audio.
Built-in Microphone
0
Microphone connected to [AUX] terminal
0
Microphone connected to [INPUT1] terminal
0
Microphone connected to [INPUT2] terminal
0
CH1 CH2 INPUT1 INPUT2
INT LINE
INPUT1 MIC
INPUT2 MIC
+48V
LCD BRIGHT PEAKING
AUTO
MANUAL
CH1 CH2
.
Selecting Audio to Be Recorded in Each
Channel
Select the audio to be recorded in CH1/CH2.
- Switch Setting
CH1 INT
INPUT1
CH2 INT
INPUT1
INPUT2
Memo :
When "INT" is set, the built-in microphone is
0
disabled if a microphone is connected to the
[AUX] terminal; audio from the microphone
connected to the [AUX] is recorded.
Set the reference input level of "INT" using [Int.
0
Mic Gain]/[AUX Gain] in the [Main Menu] B
[A/V Set] B [Audio Set] menu.
(A P102 [ Int. Mic Gain ] )
(A P102 [ AUX Gain ] )
FULL AUTO
ON
OFF
Connected Devices
Built-in Microphone
0
Microphone connected to
0
[AUX] terminal
Microphone connected to
[INPUT1] terminal
Built-in Microphone
0
Microphone connected to
0
[AUX] terminal
Microphone connected to
[INPUT1] terminal
Microphone connected to
[INPUT2] terminal
Setting Input Channel to [INPUT1]/[INPUT2]
Select the audio to input to [INPUT1] and [INPUT2]
terminals with the [INPUT1]/[INPUT2] mode
switch.
Setting
[LINE] Use this setting when connecting to
an audio device or other equipment.
The reference input level is +4 dBu.
[MIC] Use this setting when connecting to
a dynamic microphone.
[MIC+48] Use this setting when connecting to
a microphone (phantom
microphone) that requires a +48 V
power supply.
Memo :
Set the reference input level of "MIC" and "MIC
0
+48V" using [Input1 Mic Ref.]/[Input2 Mic Ref.]
in the [Main Menu] B [A/V Set] B [Audio Set]
menu.
(A P102 [ Input1 Mic Ref. ] )
(A P102 [ Input2 Mic Ref. ] )
Caution :
When connecting a device that does not require
0
a +48 V power supply, make sure that it is not
set to the "MIC+48V" position.
When the [INPUT1]/[INPUT2] mode switch is
0
set to "MIC", make sure that a microphone is
connected to the [INPUT1]/[INPUT2] terminal. If
you increase the recording level when a
microphone is not connected, noise from the
input terminal may be recorded.
When a microphone is not connected to the
0
[INPUT1]/[INPUT2] terminal, set the [INPUT1]/
[INPUT2] mode switch to "LINE" or adjust the
volume with the [CH1]/[CH2] recording level
adjustment knob.
Description
57