Managing/Editing Clips On A Pc - JVC GY-HM600U Instruction Manual

Managing/Editing Clips on
a PC
Loading Clips to the PC (USB
Connection Mode)
You can load clips to a PC by connecting the
0
camera recorder to the PC via the USB port.
Doing so enables clips stored in the SD card to
be managed and edited on the PC.
Files on the SD card can be managed/edited on
0
the connected PC in this mode only for USB
mass storage class devices that are recognized
by the said PC as a peripheral drive.
Memo :
Files cannot be written to the SD card.
0
Make sure to manage/edit files recorded in the
0
MP4 file format using the (JVC ProHD Clip
Manager) PC application software in the
bundled CD-ROM.
For details on how to install the application
0
software, refer to the [User's Guide] of the [JVC
ProHD Clip Manager] inside the bundled CD-
ROM.
1 Connect the camera recorder to the PC using a
USB cable.
A confirmation message "Change to USB
Mode?" to enable the USB connection appears.
DEVICE
.
124
AV
PC
2 Select [Change] using the cross-shaped button
(JK), and press the Set button (R).
The camera recorder switches to USB mode.
.
Memo :
If recording is in progress, the "Change to USB
0
Mode?" message appears after recording
stops.
If playback is in progress, the camera recorder
0
switches to USB mode after the file closes
automatically, such as when playback stops.
Disconnecting
Disable the connection on the PC, then remove
0
the USB cable from the camera recorder.
Doing so exits the USB mode and switches the
0
camera recorder to Camera mode.
Memo :
The procedure for disabling the USB connection
0
varies according to the PC in use. For details,
refer to the instruction manual of the PC.
2