Table of Contents
Advertisement
5 Stop backup recording.
Select [STBY] in [System] B [Record Set] B
0
[Slot Mode] B [Backup Rec] and press the
Set button (R).
(A P126 [ Slot Mode ] )
You can also press the user button that is
0
assigned with "Backup Trig".
(A P105 [User Switch Set Item] )
Recording to slot B stops, and the card slot
0
mark of slot B turns white (unselected state).
The characters "BACKUP" changes back to
0
white.
The status indicator of slot B lights up in
0
green.
White
100min
50min
100min
50min
4030 20
10
0
.
Memo :
During backup recording, if the space of one
0
card runs out, recording stops only for the card
that is full.
When recording to both slots is stopped,
0
recording in the Regen mode will be enabled for
the card slot in which recording started.
When recording is started in the other slot while
0
recording to one slot, the clip being recorded is
split and simultaneous recording to the other
card starts.
When recording is stopped for either slot A or B
0
while recording to both slots, the clip on the slot
which is still recording is split.
Although the clips are separated during
0
recording the clips can be seamlessly joined by
arranging them on the timeline of the editing
software since they are recorded seamlessly.
Clip Cutter Trig cannot be performed during
0
backup recording.
(A P87 [Splitting the Clips Freely (Clip Cutter
Trig)] )
When [Slot Mode] is set to "Backup", [Rec
0
Mode] can only be set to "Normal".
(A P125 [ Rec Mode ] )
82
Backup Rec
00: 00: 00.00
Jan 24,2015
12 :34 :56
5 . 6f t
ND 1 /16
AE
6
+
18
dB
F1. 6
P 15000K
1/ 100
Special Recording
Besides the normal recording mode, four special
recording methods are available in this camera
recorder. They are Pre Rec, Clip Continuous,
Frame Rec and Interval Rec.
Select a mode from [System] B [Record Set] B
[Rec Mode].
(A P125 [ Rec Mode ] )
Memo :
Special recording cannot be selected when
0
[System] B [Record Set] B [Record Format] B
[System] is set to "HD+Web" or "High-Speed".
Pre Rec
By setting the number of seconds in the [Pre Rec
0
Time], you can start recording video and audio
before actual recording starts based on the [Pre
Rec Time] setting.
When starting actual recording while the camera
0
recorder is in Recording Standby (STBYP)
mode, you can start recording a few seconds
earlier based on the [Pre Rec Time] setting.
Using Pre Rec allows you to record a complete
0
event without missing the initial scenes even if
you start the recording late.
Memo :
Pre Rec Time can be set in [System] B [Record
0
Set] B [Rec Mode] B [Pre Rec Time].
The following values can be selected depending
on the setting of [System] B [Record Set] B
[Record Format] B [System].
When [System] is set to "4K":
0
Fixed at "5sec"
When [System] is set to "HD" or "SD":
0
"5sec", "10sec" or "15sec"
(A P125 [ Pre Rec Time ] )
Advertisement
Chapters
Table of Contents
