Shooting; Basic Shooting Procedures - JVC GY-HM600U Instruction Manual

Basic Shooting
Procedures
Preparations
2
4
POWER
3
ON
OFF
(CHG)
MODE
.
1 Supply battery or AC adapter power to the
camera recorder.
(A P26 [Power Supply] )
2 Insert an SD card.
(A P37 [SD Card] )
3 Turn on the power of the camera recorder.
Hold down the lock button (blue) at the center of
the [POWER ON/OFF(CHG)] switch to set to
"ON". The camera recorder starts up in Camera
mode and is ready for recording.
4 Adjust the angle of the LCD monitor and
viewfinder.
(A P34 [Adjusting the LCD Monitor and
Viewfinder] )

Shooting

1 Configure the video and audio input settings.
You have to configure video settings such as
brightness adjustment (iris, gain, shutter) and
white balance adjustment in order to start
shooting. You also have to adjust the audio
input settings and audio recording level for
audio recording.
Adjusting the Brightness
0
(A P48 [Adjusting the Brightness] )
Adjusting the White Balance
0
(A P53 [Adjusting the White Balance] )
Adjusting Audio Input Settings and
0
Recording Level
(A P57 [Audio Recording] )
42
2 Press the [REC] button to start recording to the
SD card.
This camera recorder has three [REC] buttons.
Any of the [REC] buttons can be used to start/
stop recording by default.
The tally lamp lights up in red during recording.
Zoom Operation
0
(A P44 [Zoom Operation] )
4
Adjusting the Focus Manually
0
(A P45 [Focus Operation] )
Memo :
If both the slots are loaded with recordable cards
0
in the factory default, pressing the [REC] button
starts recording only to the media in the selected
slot. When [Slot Mode] in the [Main Menu] B
1
[System] B [Record Set] menu is set to "Dual",
recording can be performed simultaneously to
the cards in both the slots.
(A P69 [Dual Rec] )
The tally lamp can be turned off with [Tally
0
Lamp] in the [System] menu.
(A P104 [ Tally Lamp ] )
3 Check the most recently captured images.
Press the [C.REVIEW/7] button on the lens
0
to activate the Clip Review function. The
most recently captured images are played
back on the LCD monitor and viewfinder
screen.
After playback, the camera recorder returns
0
to standby mode (STBY).
(A P68 [Viewing Recorded Videos
Immediately (Clip Review)] )
Memo :
[Clip Review] is assigned to [C.REVIEW/7]
0
button in factory default.
[Clip Review] can also be assigned to other user
0
buttons.
(A P36 [Assigning Functions to User Buttons] )