Connecting The Headphone; Connecting Wired Remote Control - JVC GY-HM600U Instruction Manual

Connecting the
Headphone
Audio output from the [x] terminal can be
0
selected using [Monitor] in the [A/V Set] menu
as well as the [MONITOR] switch on the camera
recorder.
(A P103 [ Monitor ] )
The different combinations of settings that are
0
output from the [x] terminal and monitor
speaker are as follows.
[MONITOR]
[Monitor]
Switch
Settings
Settings
[CH1] -
[BOTH] [Mix]
[Stereo]
[CH2] -
* Audio is output from the speaker only in Media
mode. Does not output in the Camera mode.
.
Memo :
If both CH1 and CH2 are built-in microphones,
0
stereo sound is output from the [x] terminal
regardless of the [MONITOR] switch setting and
[Monitor] setting.
[x]
terminal
Speaker *
L R
CH1 CH1
CH1+CH2 CH1+CH2
CH1 CH2
CH2 CH2
Connecting Wired Remote
Control
The functions of the camera recorder can be
configured using a wired remote control.
Memo :
When the switches of the camera recorder and
0
remote control unit are operated at the same
time, the switch operation of the remote control
unit takes priority over that of the camera
recorder.
1 Connect a wired remote control to the camera
recorder.
Connect the wired remote control (sold
separately) to the [REMOTE] terminal of this
camera recorder.
REMOTE
.
Caution :
Turn off the power of the camera recorder when
0
connecting a wired remote control.
2 Turn on the power of the camera recorder.
Connect the wired
remote control
127