Turning On/Off The Power - JVC GY-HM600U Instruction Manual

Warnings by Lamp and Warning Tone
Warning status is indicated by tally lamp and
warning tone.
The tally lamp blinks.
0
The warning tone is output from the monitor
0
speaker or [x] terminal.
Memo :
If you continue to use the camera recorder while
0
the power warning is displayed, the camera
recorder will stop automatically when the battery
or supplied voltage from the AC adapter
becomes lower.
Caution :
The remaining battery power and time are
0
displayed as they are from the battery
information. Accurate data may not be displayed
depending on the battery condition. Replace the
battery as soon as possible when the remaining
battery power and time are low.

Turning On/Off the Power

Turning On the Power
1 Hold down the lock button (blue) at the center of
the [POWER ON/OFF(CHG)] switch to set to
"ON".
The camera recorder starts up in Camera mode
and is ready for shooting.
Memo :
The camera recorder always start up in Camera
0
mode when the [POWER ON/OFF(CHG)]
switch is set to "ON". Use the [MODE] button at
the side of the camera recorder to switch mode.
(A P16 [Operation Modes] )
.
Turning Off the Power
Sets the camera recorder to the recording standby
or stop mode.
1 Hold down the lock button (blue) at the center of
2 Remove the battery and the power to the [DC]
Auto Power Off function
When [Auto Power Off] in the [System] menu is set
to "On", the power turns off automatically when the
camera recorder is not operated for 5 minutes or
longer while running on battery.
Memo :
0
Caution :
0
0
0
POWER
ON
OFF
(CHG)
MODE
the [POWER ON/OFF(CHG)] switch to set to
"OFF(CHG)".
terminal (when not in use for a long time).
(A P104 [ Auto Power Off ] )
When both the battery and AC adapter are
connected, power from the AC adapter
connection will be used. As such, the [Auto
Power Off] function will not have any effect.
Do not set the [POWER ON/OFF(CHG)] switch
to "OFF(CHG)" during recording. Check that the
operation mode display is "STBY" or "STOP"
before you turn off the power.
If you have mistakenly set the [POWER ON/
OFF(CHG)] switch to "OFF(CHG)" during
recording, wait for 5 seconds or more before you
turn on the power again.
When turning off the power, first set the
[POWER ON/OFF(CHG)] switch of the camera
recorder to "OFF(CHG)". Do not remove the
battery or turn off the AC power while the
[POWER ON/OFF(CHG)] switch is set to "ON".
29