JVC GY-HM600U Instruction Manual page 131

Symptom
Images on the LCD monitor
and viewfinder screen appear
dark or blurred.
The [CH1/CH2] recording level
adjustment knob does not
work.
SD card cannot be initialized
(formatted).
Battery alarm appears even
after loading a charged
battery.
The time code and user's bit
are not displayed.
The date and time are not
displayed.
Incorrect display on the
viewfinder.
The actual recording time is
shorter than the estimated
time.
The two camera recorders are
not synchronized even though
the time codes have been
synchronized. (Z on the Slave
device is not displayed.)
Readjust the brightness of the LCD monitor and viewfinder.
0
Is the [ND FILTER] switch set to "1/64"?
0
Is the iris closed?
0
Is the shutter speed setting too high?
0
Is the amount of peaking too little? Use the [PEAKING +/-] button to
0
adjust the contour for the LCD monitor and the viewfinder screen.
(A P34 [Adjusting the LCD Monitor] )
(A P35 [Adjusting the Viewfinder] )
Is the [CH1/CH2 AUTO/MANUAL] switch set to "AUTO"?
0
Is the [FULL AUTO] switch set to "ON"?
0
Is the [FULL AUTO] switch set to "ON", and [Audio On FULL AUTO]
in [Audio Set] of the [A/V Set] menu set to "Auto"?
(A P103 [ Audio On FULL AUTO ] )
Is the write-protect switch of the SD card turned on?
Make sure that the write-protect switch is turned off.
(A P37 [Write-Protect Switch on the SD Card] )
Is the battery too old?
Even in Camera mode or Media mode, the time code and user's bit
0
may not be displayed depending to the type of display.
Is [TC/UB] of [Display Settings] in the [LCD/VF] menu set to "Off"? To
0
display the time code and user's bit, set it to "TC" or "UB".
(A P100 [ TC/UB ] )
The date and time are only displayed on the Display 1 and Display 2
0
screens in the Camera mode (during shooting).
(A P112 [Display Screen in Camera Mode] )
Is [Time Stamp] of [Record Set] in the [System] menu set to "On"? To
0
display the time code and user's bit, set it to "Off".
(A P107 [ Time Stamp ] )
Is the LCD monitor used with [LCD + VF] in the [LCD/VF] menu set to "Off"?
(A P97 [LCD/VF Menu] )
The recordable time may be shorter depending on the shooting
0
conditions or the subject.
Is the [TC IN/OUT] switch correctly set?
0
(A P64 [Synchronizing Time Code on Another Camera] )
Set [System] B [Record Set] B [Record Format] B [Frame & Bit
0
Rate] such that the two camera recorders have the same frame rate.
(A P106 [ Frame & Bit Rate ] )
Action
131