JVC GY-HM600U Instruction Manual page 55

AUTO WHITE A
OPERATION
[AWB] Activating
AUTO WHITE A
OK
Result Display
.
Caution :
Do not use highly reflective objects, such as
0
metals. Doing so may result in improper white
balance adjustment.
The Auto White function cannot provide
0
optimum white balance with an object outside
the adjustment range, for example when it
contains only a single color or not enough white
color.
Error Message
If the white balance adjustment is not correctly
completed, one of the following messages will
appear for about 3 seconds.
Message
NG : OBJECT The object used is defective.
Displayed when there is not
enough white color on the
object, or when the color
temperature is not suitable.
Use another white object and
adjust the white balance
again.
ERROR : LOW Insufficient illumination.
LIGHT Displayed when the lighting is
dark. Increase the lighting
and adjust the white balance
again.
ERROR : OVER Excessive illumination.
LIGHT Displayed when the lighting is
too bright. Decrease the
lighting and adjust the white
balance again.
White Paint Adjustment
You can fine-tune the white balance saved in
Memory A or Memory B.
1 Select [AWB Paint] in the [Main Menu] B
White Detection
Frame
.
2 Adjust the R and B values.
.
3 Press the Set button (R).
Status
.
Memo :
[Camera Process] B [White Balance] menu,
and press the Set button (R).
The White Paint Adjustment screen appears.
Use the cross-shaped button (JK) to adjust R
value and (HI) to adjust B value.
Returns to the [White Balance] screen.
Selecting [y] will usually clear the White Paint
0
Adjustment value. But when [Main Menu] B
[Camera Process] B [White Balance] B [Clear
Paint After AWB] is set to "Off", values will not
be cleared even when [y] is selected.
(A P96 [ Clear Paint After AWB ] )
1
R Value
B Value
55