JVC GY-HM600U Instruction Manual page 54

Preset Mode (PRESET)
Two different color temperature settings are
0
registered on this camera recorder. You can
switch between them using the [y] button.
(Default setting: "3200K" 1 "5600K")
Press the [y] button to switch to a different
0
color temperature.
("Preset Temp." 1 "Alternative Temp.")
1 Set the [WHT BAL B/A/PRESET] switch to
"PRESET".
2 Press the [y] button.
Setting the [Preset Temp.] or [Alternative
Temp.] Values
You can change both the color temperature
settings in the Preset mode in the menu.
1 Open the [Preset Temp.] or [Alternative
Temp.] menu.
Select [Main Menu] B [Camera Process] B
0
[White Balance] menu B [Preset Temp.]
and [Alternative Temp.], and press the Set
button (R).
The Color Temperature setting screen
0
appears.
Color Temperature Selection Screen
.
2 Select the color temperature.
When selecting from a setting value (Color
0
Temperature Selection screen), use the
cross-shaped button (JK) to select the color
temperature.
[Setting Values: 7500K, 6500K, 5600K,
5200K, 4800K, 4200K, R3200K, 3000K,
2800K]
To select detailed values (Color
0
Temperature Detailed Selection screen)
Press the cross-shaped button (I) to
0
display the Color Temperature Detailed
Selection screen.
Use the cross-shaped button (JK) to
0
select a color temperature.
[Setting Values: 2300K to 15000K (in
100K increments)]
54
Memo :
Use the cross-shaped button (I) to switch
0
between the Color Temperature Selection
screen and the Color Temperature Detailed
Selection screen.
Memory A Mode (A), Memory B Mode
(B)
Set to the white balance saved in Memory A or
0
Memory B.
When the [WHT BAL B/A/PRESET] selection
0
switch is set to "A" or "B", press the [y] button
to execute white balance. The white balance will
be automatically adjusted and the adjusted
value will be saved in Memory A or Memory B.
1 Prepare the camera recorder.
A Set the [POWER ON/OFF(CHG)] switch to "ON".
B Press the [IRIS] button to set to the Auto mode.
C Set the [FULL AUTO] switch to "OFF".
2 Set the [ND FILTER] switch according to the
lighting.
(A P53 [Setting the ND Filter] )
3 Set the [WHT BAL B/A/PRESET] selection
switch to "A" or "B".
4 Locate a place with similar lighting conditions
as the object to be shot, place a white object
near the center of the screen and zoom in to fill
the screen with white.
5 Press the [y] (Auto White Balance) button.
0
Color Temperature
0
Detailed Selection
Screen
0
The white detection frame appears when
Auto White Balance is activated. Fill the
frame with white completely.
"AUTO WHITE A OPERATION" or "AUTO
WHITE B OPERATION" appears on the
viewfinder when Auto White Balance is
activated.
When the correct white balance is achieved,
"AUTO WHITE A OK" or "AUTO WHITE B
OK" appears for about 3 seconds together
with the approximate color temperature.