JVC GY-HM600U Instruction Manual page 100

Media Remain
For setting whether to display the remaining space
of the recording SD card.
[Setting Values: ROn, Off]
Memo :
When the remaining space warning is
0
displayed, the information appears even when
"Off" is selected.
The displayed time is an estimate.
0
TC/UB
For specifying whether to display the time code
(TC) or user's bit (UB) rate in the display on the LCD
monitor and viewfinder screen.
[Setting Values: UB, RTC, Off]
Audio Meter
For specifying whether to display the audio level
meter in the display on the LCD monitor and
viewfinder screen.
[Setting Values: ROn, Off]
Battery
For setting the display of the remaining battery
power in the display on the LCD monitor and
viewfinder screen.
The battery information appears only on the
Display 1 screen in Camera mode.
(A P112 [Display 1 screen] )
Time:
0
Displays the remaining battery power in
minutes. (min)
Capacity%:
0
Displays the remaining battery power in
percentage. (%)
Voltage:
0
Displays the current battery voltage in units of
0.1 V. (V)
[Off]:
0
The remaining battery power is not displayed.
[Setting Values: RTime, Capacity%, Voltage, Off]
Memo :
The battery mark that appears before the "Time",
0
"Capacity%" or "Voltage" value changes
according to the remaining battery power.
4 : 10 % and below
D : 11 % to 30 %
C : 31% to 70 %
B : 71 % to 100 %
When the remaining battery power is low, "RES"
0
instead of the value is displayed.
Replace the battery as soon as possible.
The remaining battery power and remaining
0
time are intended as reference values for the
shooting duration.
100
Date/Time
For specifying whether to display the date and time
in the display on the LCD monitor and viewfinder
screen.
[Setting Values: ROn, Off]
Date Style
For setting the date display sequence for display
on the LCD monitor and viewfinder screen as well
as for time stamp recording.
Display examples of the setting values are as
follows.
DMY2: 30 Jun 2012
0
DMY1: 30-06-2012
0
MDY2: Jun 30, 2012
0
MDY1: 06-30-2012
0
YMD: 2012-06-30
0
[Setting Values: DMY2, DMY1, MDY1, MDY2,
YMD]
(Default values: MDY2 (U model), DMY1 (E
model))
Time Style
For setting the time display for display on the LCD
monitor and viewfinder screen as well as for time
stamp recording.
[Setting Values: 24hour, 12hour]
(Default values: 12hour (U model), 24hour (E
model))
Shutter
For setting the shutter display to be displayed on
the LCD monitor and viewfinder screen.
DEG:
0
Displays the shutter speed in degrees in the
same way as film cameras.
SEC:
0
Displays the shutter speed in seconds.
[Setting Values: DEG, RSEC]
Memo :
"DEG" is selectable only when [Frame & Bit
0
Rate] is set to "24p(HQ)" or "25p(HQ)".
When [Frame & Bit Rate] is set to other values,
the shutter display setting is fixed at "SEC" and
cannot be selected.
(A P106 [ Frame & Bit Rate ] )