Setting The Cpu Threshold Notification Types And Values - Cisco 3845 - Security Bundle Router Software Manual

Configuring SNMP
The snmp-server host command specifies which hosts receive the notifications. The snmp-server
enable trap command globally enables the mechanism for the specified notification (for traps and
informs). To enable a host to receive an inform, you must configure an snmp-server host informs
command for the host and globally enable informs by using the snmp-server enable traps command.
To remove the specified host from receiving traps, use the no snmp-server host host global
configuration command. The no snmp-server host command with no keywords disables traps, but not
informs, to the host. To disable informs, use the no snmp-server host informs global configuration
command. To disable a specific trap type, use the no snmp-server enable traps notification-types global
configuration command.

Setting the CPU Threshold Notification Types and Values

Beginning in privileged EXEC mode, follow these steps to set the CPU threshold notification types and
values:
Command
Step 1
configure terminal
Step 2
process cpu threshold type {total | process
| interrupt} rising percentage interval
seconds [falling fall-percentage interval
seconds]
Step 3
end
Step 4
show running-config
Step 5 copy running-config startup-config
Cisco ME 3800X and 3600X Switch Software Configuration Guide
25-16
Purpose
Enter global configuration mode.
Set the CPU threshold notification types and values:
• total—set the notification type to total CPU utilization.
process—set the notification type to CPU process utilization.
•
interrupt—set the notification type to CPU interrupt utilization.
•
rising percentage—the percentage (1 to 100) of CPU resources
•
that, when exceeded for the configured interval, sends a CPU
threshold notification.
• interval seconds—the duration of the CPU threshold violation in
seconds (5 to 86400) that, when met, sends a CPU threshold
notification.
falling fall-percentage—the percentage (1 to 100) of CPU
•
resources that, when usage falls below this level for the
configured interval, sends a CPU threshold notification.
This value must be equal to or less than the rising percentage
value. If not specified, the falling fall-percentage value is the
same as the rising percentage value.
Return to privileged EXEC mode.
Verify your entries.
Note To display SNMPv3 information about auth | noauth | priv
mode configuration, you must enter the show snmp user
privileged EXEC command.
(Optional) Save your entries in the configuration file.
Chapter 25 Configuring SNMP
OL-23400-01