Configuring Etherchannels - Cisco 3845 - Security Bundle Router Software Manual

Configuring EtherChannels

Figure 28-3
Configuring EtherChannels
•
•
•
•
•
•
•
•
Note Make sure that the ports are correctly configured. For more information, see the
Configuration Guidelines" section on page
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
Note
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port to which you apply the configuration.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
28-8
Load Distribution and Forwarding Methods
Switch with
source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Default EtherChannel Configuration, page 28-9
EtherChannel Configuration Guidelines, page 28-9
Configuring Layer 2 EtherChannels, page 28-10
Configuring Layer 3 EtherChannels, page 28-12
Configuring EtherChannel Load Balancing, page 28-15
Configuring the PAgP Learn Method and Priority, page 28-16
Configuring LACP Hot-Standby Ports, page 28-17
EtherChannels and Ethernet Flow Points (EFPs), page 28-19
(required)
(required)
(optional)
(optional)
(optional)
(optional)
28-9.
Chapter 28 Configuring EtherChannels
"EtherChannel
OL-23400-01