Monitoring Synce - Cisco 3845 - Security Bundle Router Software Manual

Software configuration guide
Hide thumbs Also See for 3845 - Security Bundle Router:
Table of Contents

Advertisement

Chapter 6
Configuring Synchronous Ethernet
Command
Step 9
show network-clocks
Step 10
copy running-config startup config
Use the no versions of the commands to disable the REP workaround segment selection or return to the
default settings.
This example configures the REP workaround and sets the clock input ports:
Switch (config)# rep administrative vlan 2
Switch (config)# network-clock-select output 2 SYNCE 0
Switch (config)# interface tengigabitethernet 0/1
Switch (config-if)# switchport mode trunk
Switch (config-if)# rep segment 2
Switch (config-if)# exit
Switch (config)# ql-enabled rep-segment 3
Switch (config)# network-clock-select 1 SYNCE 0
Switch (config)# network-clock-select 2 SYNCE 1
Switch (config)# interface tengigabitethernet 0/2
Switch (config-if)# switchport mode trunk
Switch (config-if)# rep segment 2
Switch (config-if)# exit
Switch (config)# network-clock-select mode revert
Switch (config)# network-clock-select wait-to-restore-timeout 300
Switch (config)# network-clock-select hold-off-timeout 300
Switch (config)# end

Monitoring SyncE

Use these privileged EXEC commands to view SyncE configuration on a switch:
OL-23400-01
show controller BITS
Switch# show controller BITS
Applique type is T1
Line Coding is B8ZS(Rx), B8ZS(Tx)
Framing is ESF(Rx), ESF(Tx)
Line Build Out is 0-133ft
No alarms detected.
show network-clocks
Switch# show network-clocks
Network Clock Configuration
Input Clock BITS: valid
Input Clock SYNCE Te0/1: valid
Input Clock SYNCE Te0/2 : valid
System Clock Lock Status (T0DPLL) : Locked
Output Clock Generated from T4 DPLL
T4 DPLL Lock Status : Locked
System Clock Selected Ref: Te0/2
T4 DPLL Selected
Ref: Te0/1
System Clock (T0 DPLL) Info:
Priority
Source
---------------------------------------------------------------
01
Te0/2
Purpose
Verify the configuration.
(Optional) Save your entries in the switch startup
configuration file.
Type
SYNCE
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Monitoring SyncE
6-11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Me 3800xMe 3600x

Table of Contents