Appendix; Unsupported Commands In Cisco Ios Release 12.2(52)Ey - Cisco 3845 - Security Bundle Router Software Manual

Unsupported Commands in
Cisco IOS Release 12.2(52)EY
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Cisco Metro Ethernet (ME) 3800X and ME 3600X switch prompt but are not
supported in this release, either because they are not tested or because of switch hardware limitations.
This is not a complete list. The unsupported commands are listed by software feature and command
mode or they are listed by command mode under "Other Unsupported Commands."
• Access Control List Commands, page C-2
• Address Resolution Protocol (ARP) Commands, page C-2
• Hot Standby Routing Protocol (HSRP) Commands, page C-2
• IGMP Snooping Commands, page C-3
IP Multicast Routing Commands, page C-3
•
IP Unicast Routing Commands, page C-4
•
Multiprotocol Label Switching (MPLS) Commands, page C-6
•
• Multicast Source Discovery Protocol (MSDP) Commands, page C-7
• NetFlow Commands, page C-7
• Quality of Service (QoS) Commands, page C-7
• RADIUS Commands, page C-8
• Simple Network Management Protocol (SNMP) Commands, page C-8
Spanning Tree Commands, page C-8
•
VLAN Commands, page C-9
•
Other Unsupported Commands, page C-9
•
OL-23400-01
A P P E N D I X
Cisco ME 3800X and 3600X Switch Software Configuration Guide
C
C-1