Executing Ip Traceroute - Cisco 3845 - Security Bundle Router Software Manual

Chapter 35 Troubleshooting
port-unreachable error to the source. Because all errors except port-unreachable errors come from
intermediate hops, the receipt of a port-unreachable error means that this message was sent by the
destination port.

Executing IP Traceroute

Beginning in privileged EXEC mode, follow this step to trace that the path packets take through the
network:
Command
traceroute ip host
Though other protocol keywords are available with the traceroute privileged EXEC command, they are
Note
not supported in this release.
This example shows how to perform a traceroute to an IP host:
Switch# traceroute ip 171.9.15.10
Type escape sequence to abort.
Tracing the route to 171.69.115.10
1 172.2.52.1 0 msec 0 msec 4 msec
2 172.2.1.203 12 msec 8 msec 0 msec
3 171.9.16.6 4 msec 0 msec 0 msec
4 171.9.4.5 0 msec 4 msec 0 msec
5 171.9.121.34 0 msec 4 msec 4 msec
6 171.9.15.9 120 msec 132 msec 128 msec
7 171.9.15.10 132 msec 128 msec 128 msec
Switch#
The display shows the hop count, IP address of the router, and the round-trip time in milliseconds for
each of the three probes that are sent.
Table 35-1
Character
*
?
A
H
N
P
Q
U
OL-23400-01
Purpose
Trace the path that packets take through the network.
Traceroute Output Display Characters
Description
The probe timed out.
Unknown packet type.
Administratively unreachable. Usually, this output means that an access list is
blocking traffic.
Host unreachable.
Network unreachable.
Protocol unreachable.
Source quench.
Port unreachable.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Using IP Traceroute
35-11