Cisco 3845 - Security Bundle Router Software Manual page 859

Chapter 35 Troubleshooting
Table 35-2 Commands for Displaying OBFL Information (continued)
Command
show logging onboard temperature
show logging onboard uptime
show logging onboard voltage
These are examples of output from the show logging onboard commands:
Switch# show logging onboard clilog
--------------------------------------------------------------------------------
CLI LOGGING SUMMARY INFORMATION
--------------------------------------------------------------------------------
COUNT COMMAND
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Switch# show logging onboard temp
--------------------------------------------------------------------------------
TEMPERATURE SUMMARY INFORMATION
--------------------------------------------------------------------------------
Number of sensors
Sampling frequency
Maximum time of storage
--------------------------------------------------------------------------------
Sensor
--------------------------------------------------------------------------------
System
--------------------------------------
Temp
0C
--------------------------------------
No historical data to display
--------------------------------------
Switch# show logging onboard uptime
--------------------------------------------------------------------------------
UPTIME SUMMARY INFORMATION
--------------------------------------------------------------------------------
First customer power on : 03/01/1993 00:06:06
Total uptime
Total downtime
Number of resets
Number of slot changes
Current reset reason
Current reset timestamp : 03/01/1993 00:05:43
Current slot
Current uptime
--------------------------------------------------------------------------------
Reset
Reason | Count
--------------------------------------------------------------------------------
No historical data to display
--------------------------------------------------------------------------------
OL-23400-01
Purpose
Display the temperature of a switch.
Display the time when a switch starts, the reason the switch restarts, and
the length of time that the switch has been running since it last restarted.
Display the system voltages of a switch.
1 hw-module module logging onboard
1 hw-module module logging onboard message level 7
4 show logging onboard
1 show logging onboard message
1 show logging onboard summary
1
:
:
: 90
: 0
: 0x0
: 1
:
| |
|
: 1
: 5 minutes
: 720 minutes
| ID | Maximum Temperature 0C
1 41
Sensor ID
0 years 20 weeks 4 days
0 years 0 weeks 0 days
0 years 0 weeks 2 days
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Using On-Board Failure Logging
6 hours 20 minutes
0 hours 0 minutes
6 hours 0 minutes
35-17