Cisco 3845 - Security Bundle Router Software Manual page 256

Monitoring EVC
Table 11-3 Supported show Commands
Command
show bridge-domain [n]
show bridge-domain n split-horizon
[group {group_id | all}]
show ethernet service instance detail
show mac address-table
show mac address-table bridge-domain
bridge-domain id
show mac address-table count
bridge-domain bridge-domain id
show mac address-table learning
bridge-domain bridge-domain id
This is an example of output from the show ethernet service instance detail command:
Switch# show ethernet service
Service Instance ID: 1
Associated Interface: GigabitEthernet0/13
Associated EVC: EVC_P2P_10
L2protocol drop
CE-Vlans:
Encapsulation: dot1q 10 vlan protocol type 0x8100
Interface Dot1q Tunnel Ethertype: 0x8100
State: Up
EFP Statistics:
EFP Microblocks:
****************
Microblock type: Bridge-domain
Bridge-domain: 10
Cisco ME 3800X and 3600X Switch Software Configuration Guide
11-30
Description
When you enter n, this command displays all the members of the specified
bridge-domain, if a bridge-domain with the specified number exists.
If you do not enter n, the command displays all the members of all
bridge-domains in the system.
When you do not specify a group group_id, this command displays all the
members of bridge-domain n that belong to split horizon group 0.
If you specify a numerical group_id, this command displays all the members of
the specified group id.
When you enter group all, the command displays all members of any split
horizon group.
This command displays detailed service instance information, including Layer
2 protocol information. This is an example of the output:
Switch# show ethernet service instance detail
Service Instance ID: 1
Associated Interface: Ethernet0/0
Associated EVC:
L2protocol tunnel pagp
CE-Vlans:
State: Up
EFP Statistics:
Pkts In
This command displays dynamically learned or statically configured MAC
security addresses.
This command displays MAC address table information for the specified bridge
domain.
This command displays the number of addresses present for the specified bridge
domain.
This command displays the learning status for the specified bridge domain.
Pkts In Bytes In Pkts Out
214 15408
Chapter 11
Bytes In Pkts Out
0 0
instance id 1 interface gigabitEthernet 0/1 detail
Bytes Out
97150 6994800
Configuring Ethernet Virtual Connections (EVCs)
Bytes Out
0 0
OL-23400-01