Cisco 3845 - Security Bundle Router Software Manual page 531

Chapter 27 Configuring QoS
Command
Step 3
match {cos cos-list | cos inner
cos-list | discard-class value | ip
dscp dscp-list | ip precedence
ip-precedence-list | mpls
experimental topmost value|
qos-group value | vlan vlan-list
| vlan inner vlan-list}
Step 4 end
Step 5 show class-map
Step 6 copy running-config
startup-config
Use the no form of the appropriate command to delete an existing class map or remove a match criterion.
OL-23400-01
Purpose
Define the match criterion to classify traffic. By default, no match criterion is
defined. Only one match type per class map is supported, and only one ACL per
class map is supported.
Enter cos cos-list to match a packet based on the outer VLAN tag or the
•
service-provider CoS value. You can specify up to four Layer 2 CoS values
to match against the packet. Separate each value with a space. The range is 0
to 7.
Enter cos inner cos-list to match a packet based on the inner CoS value. For
•
packets with less than two tags, this command has no effect. You can specify
up to four Layer 2 CoS values to match against the packet. Separate each
value with a space. The range is 0 to 7.
Enter discard-class value to match a packet based the drop precedence for a
•
packet during congestion management. The range is 0 to 7. Matching discard
class is supported only in output policy maps
• For ip dscp dscp-list, enter a list of up to eight IPv4 DSCP values to match
against incoming packets. Separate each value with a space. You can enter
multiple dscp-list lines to match more than eight DSCP values. The numerical
range is 0 to 63. You can also configure DSCP values in other forms (af
numbers, cs numbers, default, or ef).
For ip precedence ip-precedence-list, enter a list of up to four IPv4
•
precedence values to match against incoming packets. Separate each value
with a space. You can enter multiple ip-precedence-list lines to match more
than four precedence values. The range is 0 to 7.
For mpls experimental topmost value, enter a list of up to eight MPLS
•
experimental labels. You can enter multiple lines to match more than eight
MPLS experimental values. This keyword matches only valid MPLS packets.
Separate each value with a space. The range is 0 to 7.
For qos-group value, specify the QoS group number. The range is 0 to 99.
•
Matching of QoS groups is supported only in output policy maps.
Enter vlan vlan-id to match a packet based on the outermost, service-provider
•
VLAN ID (S-VLAN). For untagged packets, this matches the default VLAN
associated with the packets from the port or EFP.
You can enter a single VLAN ID or a range of VLANs separated by a hyphen.
The range is from 1 to 4095.
Enter vlan inner vlan-id to match a packet based on the C-VLAN, the inner
•
customer VLAN ID of an 802.1Q tunnel. For packets with less than 2 tags,
the command has no effect.
You can specify a single VLAN identified by a VLAN number or a range of
VLANs separated by a hyphen. The range is 1 to 4094.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring QoS
27-43