Encapsulation - Cisco 3845 - Security Bundle Router Software Manual

Understanding EVC Features
When you enter service instance configuration mode, you can configure these options:
•
•
•
•
•
•
•
•
•
•
•
On a Layer 2 port with no service instance configured, multiple switchport commands are available
(access, backup, block, host, mode, and trunk). When one or more service instances are configured on
a Layer 2 port, no switchport commands are accepted on that interface.

Encapsulation

Encapsulation defines the matching criteria that maps a VLAN, a range of VLANs, cost of service (CoS)
bits, Ethertype, or a combination of these to a service instance. You configure encapsulation in service
instance configuration mode. You must configure one encapsulation command per EFP (service
instance).
Use the encapsulation service-instance configuration mode command to set encapsulation criteria.
Different types of encapsulations are default, dot1q, priority-tagged and untagged. Valid Ethertypes
(type) are ipv4, ipv6, pppoe-all, pppoe-discovery, and pppoe-session.
Encapsulation classification options also include:
•
•
•
•
•
After you have entered an encapsulation method, these keyword options are available in service instance
configuration mode:
•
•
Cisco ME 3800X and 3600X Switch Software Configuration Guide
11-4
default—Sets a command to its defaults
description—Adds a service instance specific description
encapsulation—Configures Ethernet frame match criteria
errdisable—Configures error disable
ethernet—Configures Ethernet-lmi parameters
exit— Exits from service instance configuration mode
l2protocol—Configures Layer 2 control protocol processing
mac—Commands for MAC address-based features
no—Negates a command or sets its defaults
service-policy —Attaches a policy-map to an EFP
shutdown—Takes the service instance out of service
Enter the [no] shutdown service-instance configuration mode to shut down or bring up a service
instance.
outer tag VLAN
outer tag CoS
inner tag VLAN
inner tag CoS
payload ethertype—any ethertype tag after the VLAN tag
bridge-domain—Configures a bridge domain
rewrite—Configures Ethernet rewrite criteria
Chapter 11 Configuring Ethernet Virtual Connections (EVCs)
OL-23400-01