Configuring Static Remote Mep - Cisco 3845 - Security Bundle Router Software Manual

Chapter 32 Configuring Ethernet OAM, CFM, and E-LMI
Command
Step 4
service {ma-name | ma-number | vpn-id vpn} {vlan
vlan-id}
Step 5 mep mpid identifier
Step 6
end
Step 7
ethernet cfm mep crosscheck {enable | disable}
domain domain-name {vlan {vlan-id | any} | port}
Step 8
show ethernet cfm maintenance-points remote
crosscheck
Step 9
show ethernet cfm errors [configuration]
Step 10 copy running-config startup-config
Use the no form of each command to remove a configuration or to return to the default settings.

Configuring Static Remote MEP

Beginning in privileged EXEC mode, follow these steps to configure Ethernet CFM static remote MEP:
Command
Step 1
configure terminal
Step 2
ethernet cfm domain domain-name level level-id
OL-23400-01
Purpose
Define a customer service maintenance association name
or number or VPN ID to be associated with the domain, and
a VLAN ID, and enter ethernet-cfm-service configuration
mode.
• ma-name—a string of no more than 100 characters that
identifies the MAID.
• ma-number—a value from 0 to 65535.
• vpn-id vpn—enter a VPN ID as the ma-name.
vlan vlan-id—VLAN range is from 1 to 4094. You
•
cannot use the same VLAN ID for more than one
domain at the same level.
Define the MEP maintenance end point identifier in the
domain and service. The range is 1 to 4094.
Return to privileged EXEC mode.
Enable or disable CFM crosscheck for one or more VLANs
or a port MEP in the domain.
• domain domain-name—Specify the name of the
created domain.
vlan {vlan-id | any}—Enter the service provider
•
VLAN ID or IDs as a VLAN-ID (1 to 4094), a range of
VLAN-IDs separated by a hyphen, or a series of
VLAN IDs separated by comma. Enter any for any
VLAN.
• port—Identify a port MEP.
Verify the configuration.
Enter this command after you enable CFM crosscheck to
display the results of the crosscheck operation. Enter the
configuration keyword to display the configuration error
list.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Define a CFM domain, set the domain level, and enter
ethernet-cfm configuration mode for the domain. The
maintenance level number range is 0 to 7.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring Ethernet CFM
32-11