Bridge Multicast Forbidden Address - Dell PowerConnect 3524 Cli Reference Manual

bridge multicast forbidden address

The bridge multicast forbidden address Interface Configuration (VLAN) mode command forbids
adding a specific Multicast address to specific ports. Use the no form of this command to return to the
default configuration.
Syntax
• bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} {add | remove}
{ethernet interface-list | port-channel port-channel-number-list}
• no bridge multicast forbidden address {mac-multicast-address | ip-multicast-address}
• add — Adds ports to the group.
• remove — Removes ports from the group.
• mac-multicast-address — A valid MAC Multicast address.
• ip- multicast-address — A valid IP Multicast address.
• interface-list — Separate non-consecutive Ethernet ports with a comma and no spaces; hyphen is
used to designate a range of ports.
• port-channel-number-list — Separate non-consecutive valid port-channels with a comma and no
spaces; a hyphen is used to designate a range of port-channels.
Default Configuration
No forbidden addresses are defined.
Command Modes
Interface Configuration (VLAN) mode.
User Guidelines
• Before defining forbidden ports, the Multicast group should be registered.
Examples
The following example forbids MAC address 0100.5e02.0203 on port 2/e9 within VLAN 8.
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 0100.5e.02.0203
Console(config-if)# bridge multicast forbidden address
0100.5e02.0203 add ethernet 2/e9
104
Address Table Commands