Show Stack - Dell PowerConnect 3524 Cli Reference Manual

Example
The following example reloads Unit 2 of the stack.
Console(config)# stack reload unit 2

show stack

The show stack User EXEC mode command displays information about the status of a stack.
Syntax
• show stack [unit unit]
• unit — Specifies the number of the unit. (Range: 1 - 6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example displays stack status.
Console> show stack
Unit MAC Address
---- --------------
1 00:33:97:02:16:00 1.0.0.7
2 00:33:97:02:21:00 1.0.0.7
3 00:33:97:02:12:00 1.0.0.7
4 00:33:97:02:18:00 1.0.0.6
5 00:33:97:02:14:00 1.0.0.7
6 00:33:97:02:22:00 1.0.0.7
7 00:33:97:02:11:00 1.0.0.7
8 00:33:97:02:19:00 1.0.0.7
Software Master
-------- -------
Forced
Enabled
Disabled 2
Disabled 3
Disabled 4
Disabled 5
Disabled 8
Disabled 7
Uplink Downlink Status
------ -------- ------
8 2
1 3
4
5
6
7
6
1
System Management
Master
backup
Slave
Slave
Slave
Slave
Slave
Slave
427