Port Storm-Control Broadcast Rate - Dell PowerConnect 3524 Cli Reference Manual

Example
The following example enables storm control on Ethernet port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# port storm-control broadcast enable

port storm-control broadcast rate

The port storm-control broadcast rate Interface Configuration (Ethernet) mode command configures
the maximum Broadcast rate. Use the no form of this command to return to the default configuration.
Syntax
port storm-control broadcast rate rate
•
• no port storm-control broadcast rate
• rate —Maximum kilobytes per second of Broadcast and Multicast traffic on a port. (Range: 70 -
1000000)
Default Configuration
The default configuration is disabled.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
• Use the port storm-control broadcast enable Interface Configuration mode command to enable
Broadcast storm control.
Example
The following example configures the maximum storm control Broadcast rate at 900 Kbits/Sec on
Ethernet port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# port storm-control broadcast rate 900
Ethernet Configuration Commands
181