Port Storm-Control Include-Multicast - Dell PowerConnect 3524 Cli Reference Manual

The following table describes the fields shown in the display.
Field
InOctets
InUcastPkts
InMcastPkts
InBcastPkts
OutOctets
OutUcastPkts
OutMcastPkts
OutBcastPkts
FCS Errors
Single Collision Frames
Late Collisions
Oversize Packets
Internal MAC Rx Errors
Received Pause Frames
Transmitted Pause Frames Counted MAC Control frames transmitted on this interface with an opcode

port storm-control include-multicast

The port storm-control include-multicast Interface Configuration (Ethernet) mode command counts
Multicast packets in Broadcast storm control. Use the no form of this command to disable counting
Multicast packets.
Syntax
• port storm-control include-multicast
• no port storm-control include-multicast
Count unknown Unicast packets.
Default Configuration
Multicast packets are not counted.
Description
Counted received octets.
Counted received Unicast packets.
Counted received Multicast packets.
Counted received Broadcast packets.
Counted transmitted octets.
Counted transmitted Unicast packets.
Counted transmitted Multicast packets.
Counted transmitted Broadcast packets.
Counted received frames that are an integral number of octets in length but
do not pass the FCS check.
Counted frames that are involved in a single collision, and are subsequently
transmitted successfully.
Number of times that a collision is detected later than one slotTime into the
transmission of a packet.
Counted frames received that exceed the maximum permitted frame size.
Counted frames for which reception fails due to an internal MAC sublayer
receive error.
Counted MAC Control frames received with an opcode indicating the
PAUSE operation.
indicating the PAUSE operation.
Ethernet Configuration Commands
179