lldp tx-delay
The lldp tx-delay Global Configuration mode command specifies the delay between successive LLDP
frame transmissions initiated by value/status changes in the LLDP local systems MIB. Use the no form of
this command to revert to the default setting.
Syntax
•
lldp tx-delay seconds
•
no lldp tx-delay
Parameters
•
seconds — Specifies the delay in seconds between successive LLDP frame transmissions initiated
by value/status changes in the LLDP local systems MIB. Range 1-8192 second.
Default Configuration
The default value is 2 seconds
Command Modes
Global Configuration mode.
Usage Guidelines
•
It is recommended that the TxDelay be less than 0.25 of the LLDP timer interval.
Examples
The following example specifies the delay between successive LLDP frame transmissions initiated by
value/status changes in the LLDP local systems MIB.
Console (config) # lldp tx-delay 7
lldp optional-tlv
To specify which optional TLVs from the basic set should be transmitted, use the lldp optional-tlv
command in interface configuration mode. Use the no form of this command to revert to the default
setting.
Syntax
lldp optional-tlv tlv1 [tlv2 ... tlv5]
no lldp optional-tlv
•
tlv — Specifies TLV that should be included. Available optional TLVs are: port-desc, sys-name,
sys-desc, sys-cap, 802.3-mac-phy.
255
LLDP Commands