Juniper T1600 Hardware Manual page 215

Copyright © 2010, Juniper Networks, Inc.
Table 40: Tools and Parts Required for Component
Replacement (continued)
Components
Craft interface
DC power supply
Three-input 240-A DC power supply or
Four-input 240-A DC power supply
DC power supply cable
Fan tray (front or rear)
FPC
PIC
Routing Engine
Chapter 17: Replacing T1600 Router Hardware Components
Tool or part
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) nut driver
CAUTION: You must use an appropriate
torque-controlled tool to tighten the nuts.
Applying excessive torque damages the
terminal studs and the power supply. The
absolute maximum torque that may be applied
to this nut is 45 in-lb (5.0 Nm).
Wire cutters
Flashlight
Nonconductive sharp object
7/16-in. (11 mm) nut driver
CAUTION: You must use an appropriate
torque-controlled tool to tighten the nuts.
Applying excessive torque damages the
terminal studs and the power supply. The
absolute maximum torque that may be applied
to this nut is 45 in-lb (5.0 Nm).
Wire cutters
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Blank panel (if component is not reinstalled)
Electrostatic bag or antistatic mat
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic PICs or
fiber-optic PIC cables
Flat-blade (–) screwdriver for Type 1 PICs
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic bag or antistatic mat
Blank panel (if component is not reinstalled)
191