Juniper T1600 Hardware Manual page 292

T1600 Core Router Hardware Guide
268
NOTE: For power supplies set to
router), connect two DC power cables, one for RETURN and one for -48
V, to each of the three inputs.
Loosen the captive screw or screws on the cable restraint on the right edge of the
8.
power supply faceplate.
Route the DC power cables through the cable restraint.
9.
Tighten the cable restraint captive screw or screws to hold the power cables in place.
10.
Verify that the ground and power cabling are correct, that they are not touching or
11.
blocking access to other hardware components, and that they do not drape where
people could trip on them.
Replace the clear plastic cover over the terminal studs on the faceplate.
12.
Figure 153: Connecting Power Cables to the Power Supply
mode (required for the T1600
3-INPUT
Copyright © 2010, Juniper Networks, Inc.