Juniper T1600 Hardware Manual page 266

T1600 Core Router Hardware Guide
242
Figure 137: Installing an FPC
Gently rest the bottom edge of the FPC on the bottom edge of the slot opening, making
12.
contact a short distance forward of the power connector.
CAUTION: Take care not to bend or otherwise damage the power
connector prongs.
Slowly slide the FPC into the slot until you feel resistance.
13.
Align the ejector handles on the FPC faceplate in a position close to horizontal.
14.
Simultaneously turn both ejector handles clockwise until you cannot turn them farther.
15.
If you are installing a Type 2 FPC or Type 3 FPC, tighten the screws inside the ejector
16.
handles to secure the FPC. Do not overtighten them.
If any of the PICs on the FPC connect to fiber-optic cable, remove the rubber safety
17.
cap from each transceiver and cable.
Do not bend or damage prongs
on power connector
Copyright © 2010, Juniper Networks, Inc.