Replacing a T1600 T-CB
Copyright © 2010, Juniper Networks, Inc.
user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state
...
If the host subsystem is functioning as the master, switch it to backup using the CLI
2.
command:
user@host> request chassis routing-engine master switch
To halt the router:
3.
user@host> request system halt
(If two Routing Engines are installed, also issue the command on the backup Routing
Engine.) Wait until a message appears on the console confirming that the operating
system has halted.
The command shuts down the Routing Engine cleanly, so its state information is
preserved. For more information about the command, see the Junos OS System Basics
and Services Command Reference.
NOTE: The SIBs might continue forwarding traffic for approximately 5
minutes after the
Removing a T1600 T-CB on page 216
Installing a T1600 T-CB on page 217
Chapter 17: Replacing T1600 Router Hardware Components
Master
command has been issued.
request system halt
215