Juniper T1600 Hardware Manual page 163

Copyright © 2010, Juniper Networks, Inc.
Connect the wires to the AC terminal block on the three-phase delta AC power supply
11.
(Figure 88 on page 139). Use 1/4-in. slotted screwdriver to loosen the input terminal
or grounding point screw, insert each wire into the grounding point or input terminal,
and tighten the screw.
Insert the wire labeled
a.
Insert the wire labeled
b.
Insert the wire labeled
c.
Insert the wire labeled
d.
Figure 88: Connecting Power to a Three-Phase Delta AC Power Supply
L1 L2 L3
NOTE: The color of each AC power wire might vary.
Verify that the power cable connections are correct.
12.
Using a number 2 Phillips (+) screwdriver, tighten the two captive screws on the metal
13.
AC wiring compartment.
Use the provided plastic cable tie to fasten the AC power cord to the power supply.
14.
Verify that the AC power cord is not touching or blocking access to router components,
15.
and that it does not drape where people could trip on it.
Repeat the procedure for the other three-phase delta AC power supply.
16.
Chapter 13: Providing Power to the T1600 Router
GND into the grounding point labeled
into the input terminal.
L1 L1
L2 into the L2 input terminal.
into the input terminal.
L3 L3
L1 L2 L3
GND .
139