Installing An Srp I/O Module; Installing An Srp Module - Juniper E Series Hardware Manual

NOTE:
modules are not interchangeable between systems. For example, the 10-Gbps SRP
module used in ERX-7xx/14xx models cannot be used in an ERX-310 router, and
vice versa.
NOTE:
system diagnostics will fail.

Installing an SRP I/O Module

To install an SRP I/O module:
1. Ground yourself by using an antistatic wrist strap or other device.
2. With a Phillips screwdriver, loosen the captive screws that secure the blank
3. Remove the SRP I/O module from its antistatic bag.
4. Slide the module into the chassis by placing it between the guides of the
NOTE:
5. Tighten the module's captive screws using a Phillips screwdriver. Turn both

Installing an SRP Module

To install an SRP module:
1. Ground yourself by using an antistatic wrist strap or other device.
NOTE:
2. Choose the slot in which you want to install the module.
3. With a Phillips screwdriver, loosen the captive screws that secure the blank
Because of different physical dimensions and switch fabric capabilities, SRP
Install the SRP I/O module before you install the SRP module; otherwise, the
faceplate covering the empty chassis slot, if present, and remove the faceplate.
selected slot and pushing the module until it stops.
See figures in Chapter 1, E-series Overview, for module locations.
screws several times before tightening them completely to allow the module to
sit correctly.
See figures in Chapter 1, E-series Overview, for module locations.
! ERX-14xx models – slot 6 or 7
! ERX-7xx models – slot 0 or 1
! ERX-310 router – slot 0
faceplate covering the empty chassis slot, if present, and remove the faceplate.
Chapter 5: Installing Modules
Installing SRP I/O and SRP Modules
! 45