Installing An Srp I/O Module; Installing An Srp Module - Juniper E Series Hardware Manual

ERX 7.0.x Hardware Guide
NOTE: Install the SRP I/O module before you install the SRP module; otherwise, the
system diagnostics will fail.

Installing an SRP I/O Module

To install an SRP I/O module:
1.
2.
3.
4.
NOTE: See figures in "E-series Overview" on page 3, for module locations.
5.

Installing an SRP Module

To install an SRP module:
1.
NOTE: See figures in "E-series Overview" on page 3, for module locations.
2.
3.
42
Installing SRP I/O and SRP Modules
Ground yourself by using an antistatic wrist strap or other device.
With a Phillips screwdriver, loosen the captive screws that secure the blank
faceplate covering the empty chassis slot, if present, and remove the faceplate.
Remove the SRP I/O module from its antistatic bag.
Slide the module into the chassis by placing it between the guides of the
selected slot and pushing the module until it stops.
Tighten the module's captive screws using a Phillips screwdriver. Turn both
screws several times before tightening them completely to allow the module
to sit correctly.
Ground yourself by using an antistatic wrist strap or other device.
Choose the slot in which you want to install the module.
ERX-14xx models—Slot 6 or 7
ERX-7xx models—Slot 0 or 1
ERX-310 router—Slot 0
With a Phillips screwdriver, loosen the captive screws that secure the blank
faceplate covering the empty chassis slot, if present, and remove the faceplate.