Installing An Srp I/O Module; Installing An Srp Module - Juniper E-Series Installation And User Manual

5-8 CHAPTER 5
Installing Modules

Installing an SRP I/O Module

Installing an SRP Module

To install an SRP I/O module:
1
Ground yourself by using an antistatic wrist strap or other device.
2
With a Phillips screwdriver, loosen the captive screws that secure the
blank faceplate covering the empty chassis slot, if present, and
remove the faceplate.
3
Remove the SRP I/O module from its antistatic bag.
4
Slide the module into the chassis by placing it between the guides of
the selected slot and pushing the module until it stops.
Note: See figures in Chapter 1, E-Series
5
Tighten the module's captive screws using a Phillips screwdriver.
Turn both screws several times before tightening them completely to
allow the module to sit correctly.
To install an SRP module:
1
Ground yourself by using an antistatic wrist strap or other device.
Note: See figures in Chapter 1, E-Series
2
Choose the slot in which you want to install the module.
• ERX-14xx models – slot 6 or 7
• ERX-7xx models – slot 0 or 1
• ERX-310 router – slot 0
3
With a Phillips screwdriver, loosen the captive screws that secure the
blank faceplate covering the empty chassis slot, if present, and
remove the faceplate.
4
Remove the SRP module from its antistatic bag.
5
Verify that the ejectors are in the open position, as shown in
Figure 5-5.
Overview, for module locations.
Overview, for module locations.