Download Print this page

Next Steps; Safety Warnings Summary - Juniper NFX150-C-S1 Quick Start Manual

Network services platform

Advertisement

Connect the laptop to one of the front panel LAN ports such as
2.
an IP address by the DHCP server running on the interface.
Open a browser on your laptop, navigate to
3.

Next Steps

For information on downloading the image, provisioning virtual network functions (VNFs), and performing initial configuration
using the CLI, see the Getting Started with NFX150 available at:
https://www.juniper.net/documentation/en_US/release-independent/junos/information-products/pathway-pages/nfx-series/product/

Safety Warnings Summary

This is a summary of safety warnings. For a complete list of warnings, including translations, see the NFX150 documentation at
https://www.juniper.net/documentation/en_US/release-independent/junos/information-products/pathway-pages/nfx-series/product/
WARNING:
Failure to observe the following safety warnings can result in personal injury or death:
Permit only trained and qualified personnel to install or replace device components.
Perform only the procedures described in this Quick Start Guide and the NFX150 documentation. Other services
must be performed only by authorized service personnel.
Before installing the device, read the planning instructions in the NFX150 documentation to make sure that the
site meets power, environmental, and clearance requirements for the device.
Before connecting the device to a power source, read the installation instructions in the NFX150 documentation.
Before installing or after removing an electrical component, always place it component-side up on an antistatic
mat placed on a flat, stable surface or in an antistatic bag.
Do not work on the device or connect or disconnect cables during electrical storms.
Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces, and
watches. Metal objects heat up when connected to power and ground and can cause serious burns or become
welded to the terminals.
Reference
Technical Support
https://www.juniper.net/support/requesting-support.html
Getting Started with NFX150
https://www.juniper.net/documentation/en_US/release-independent/junos/information-products/pathway-pages/nfx-series/product/
NFX150 Hardware Guide
https://www.juniper.net/documentation/en_US/release-independent/junos/information-products/pathway-pages/nfx-series/product/
Supported Transceivers
https://apps.juniper.net/hct/product/#prd=NFX150
Juniper Networks, the Juniper Networks logo, Juniper, and Junos are registered trademarks of Juniper Networks, Inc. and/or its affiliates in the United States
and other countries. All other trademarks may be property of their respective owners. Juniper Networks assumes no responsibility for any inaccuracies in this
document. Juniper Networks reserves the right to change, modify, transfer, or otherwise revise this publication without notice. Copyright © 2018 Juniper
Networks, Inc. All rights reserved. Part Number: 530-083998 Rev. 01, March 2018.
heth-0-0
https://www.juniper.net
, and verify your connectivity.
NFX150-C-S1 Network Services Platform Quick Start
,
,
, or
heth-0-1
heth-0-2
heth-0-3
. The laptop is assigned
.

Advertisement

loading