Effects And Parameters; Editing A Preset's Effects - DigiTech GNX3000 Owner's Manual

Effects and Parameters

Use Effect Select buttons
to select Effect row
LEDs indicate the
selected row
GNX3000 Owner' s Manual
Effects and Parameters
The GNX3000 features a comprehensive set of effects for creating just the sound
you need for any musical application. These effects are connected in a standard
effects chain with pickup simulator, wah, compressor, Whammy
stompbox effects placed before the amps. Effects placed post amp are those that
typically sound best when heard in stereo like modulation effects, delay and reverb.
The following diagram show the signal path through the effects of the GNX3000:
(WHAMMY,
TALKER)

Editing a Preset's Effects

The EFFECTS section is accessed with the EFFECT SELECT UP/DOWN buttons. The
Matrix LEDs light one at a time to identify the selected row of effects. Each effect
has up to 5 Parameters that can be edited. Pressing the STATUS button turns the
effect row on and off. The 5 knobs control the Parameters listed directly beneath the
corresponding knob. Each effect's parameter is labeled in the Matrix. When a knob is
turned, the corresponding parameter name and value appear in the displays.
Status button
turns selected
effect on or off
Rotating the knobs increases or decreases the value of the parameter (except for Type
which selects different effect types) and you hear the change in real time. Changing
presets, or turning the power off before storing any changes will erase your changes
and revert to the stored values. When the preset has been edited, the STORE BUTTON
LED turns on indicating that a change has been made.
50
(IPS, PITCH,
DETUNE)
Parameter name and value
are shown in display
Edit
Each knob adjusts the
column of parameters
directly below knob for
the selected Effect row
/IPS, and distortion
TM
GNX3000
PRESET SPEAKER
LEVEL COMPENSATION OUTPUTS