Table of Contents
Advertisement
Expression Pedal Assignment
GNX3000 Owner' s Manual
1. Press either EFFECT SELECT button until the EXPRESSION ASSIGN row is selected.
2. Press the STATUS button multiple times until
3. Rotate KNOB 2 to set the heel position of the wah effect. Ranges from 0 to 99.
4. Rotate KNOB 3 to set the toe position of the wah effect. Ranges from 0 to 99.
5. Press EXIT when finished.
Amp Channel Footswitch
From the factory, the AMP CHANNEL FOOTSWITCH selects between the Channel 1
Amp, Channel 2 Amp, and the Warped Amp state when the GNX3000 is in Stompbox
Mode. However, you can configure the function of the AMP CHANNEL FOOTSWITCH
within a preset.
The procedure for assigning the function of the AMP CHANNEL FOOTSWITCH is as
follows:
1. Press either EFFECT SELECT button until the EXPRESSION ASSIGN row is selected.
2. Press the STATUS button until the display reads
3. Rotate KNOB 1 to select the Amp Footswitch function. Your choices include:
CH1-CH2
-
Switches between the Channel 1 (Green) and the Channel 2
(Red) Amp Channels.
-
Switches between the Channel 1 (Green) and the Warped Amp
CH1-Warp
(Yellow) Channels.
-
Switches between the Channel 2 (Red) and the Warped Amp
CH2-Warp
(Yellow) Channels.
-
Switches between the Channel 1(Green), the Warped (Yellow)
C1-c2-wp
Channel, and the Channel 2 (Red) Channels.
4. Store your Amp Footswitch assignment to your preset. See page 92 for more
information on storing presets.
LFOs
The GNX3000 includes two low frequency oscillators (LFO1 and LFO2) that can each
be assigned to a single parameter. A low frequency oscillator automatically varies the
value of the assigned parameter at a steady rate. A minimum and maximum value can
be assigned. For instance: if the Amp Gain was assigned to LFO1, and the minimum
value was set at 1 and the maximum value was set at 99, the GNX3000 would
automatically sweep the amount of distortion from clean to distorted and back to
clean. Individual LFO speeds can also be assigned. In the previous example, the LFO
speed would determine the length of time it took the LFO to sweep from the clean to
the distorted sound.
76
appears in the display.
WAH PDL
(Amp Footswitch).
AMP FS
Advertisement
Table of Contents
