Table of Contents
Advertisement
Amp Control
Buttons
AMP/CABINET
SECTION
Status Button
Effect Select
Buttons
EFFECTS
Viewing/Editing GeNetX
SECTION
To view or edit an amp parameter's current value, you must first select the row in which
the parameter resides using the AMP CONTROL buttons located to the left of the amp
parameter rows. After selecting the desired row, use the STATUS button and KNOBS
to adjust the parameters. Turning a knob one click position will display the current
value of the selected parameter. If a KNOB is turned again within three seconds, the
parameter value will be changed and the new value will be displayed. If a KNOB is not
turned within three seconds, the main display returns back to the preset name.
Amp Control
NOTE: If a parameter name is shown in the display while editing both Amps and
Buttons
Effects, the DATA WHEEL can change the value as well as the Knobs.
AMP/CABINET
SECTION
Status Button
Effect Select
Buttons
EFFECTS
SECTION
Viewing/Editing Effect Parameter Values
To view or edit an effect parameter's current value, you must first select the row in
which the desired parameter resides by using the EFFECT SELECT buttons. They are
located to the left of the STATUS button. After selecting the desired effect, use the
STATUS button and knobs to adjust the effect's individual parameters. Parameter
adjustments will show in the displays as edits are made. To exit effect editing, press the
EXIT button in the Control Panel.
NOTE: If a parameter name is shown in the display while editing both Amps and
Effects, the DATA WHEEL can change the value as well as the Knobs.
NAME 64
and Amp Parameter Values
TM
Knobs
Data Wheel
NAME 64
Knobs
39
GNX3000 Owner' s Manual
Data Wheel
GNX3000 Owner' s Manual
Advertisement
Table of Contents
