Table of Contents
Advertisement
Creating a Preset
GNX3000 Owner' s Manual
Turn the Compressor Off
We don't use compression in our preset so, we need to turn the Compressor off.
To turn the Compressor off, do the following:
1. Press the EFFECT SELECT DOWN button. The Compression LED lights and the
display shows the current status of the Compressor.
2. If the Compressor is on, press the STATUS button until the red display reads off
(
).
Of
Turn the Whammy
TM
We don't want Whammy, IPS, or Talker effects in this preset. To turn these effects
off, do the following:
1. Press the EFFECT SELECT DOWN button, and the Whammy/IPS/Talker LED is
lit.
2. If the display indicates that one of these effects is active, press the STATUS
button until the display reads off (
Turn the Stompbox Modeling Off
To turn the Stompbox Modeling off for this preset, do the following
1. Press the EFFECT SELECT DOWN button until the Stompbox LED is lit.
2. If the display indicates that it is active, press the STATUS button until the
display reads off (
Of
Adjust the Noise Gate
For our example, we want our Noise Gate to open quickly with a relatively weak
signal. This type of gate uses the Silencer
time. To create this type of Noise Gate, do the following:
1. Press the AMP FOOTSWITCH to select the Channel 2 Amp (
high gain model.
2. Press the EFFECT SELECT DOWN button and the Noise Gate's LED lights.
3. If the display reads off (
(
).
On
4. Rotate KNOB 1 until the display reads
5. Rotate KNOB 2 to set the Threshold to
depending upon your guitar).
6. Rotate KNOB 3 to set the Attack Time to
88
/IPS/Talker
Off
TM
).
Of
).
with a low threshold and short attack
TM
), press the STATUS button until the display reads on
Of
SILeNCeR
(this may need to be adjusted
37
(fast attack).
0
), our
CH2 AMP
for the type of gate.
Advertisement
Table of Contents
