Select Models For The Preset's Channels - DigiTech GNX3000 Owner's Manual

Creating a Preset
1. Press the GENETX
Amp Control button
GNX3000 Owner' s Manual
5. Now we need to choose one of the 9 User HyperModel locations. Use the
DATA WHEEL to select a an empty user location. The display should read
(Empty) and the red numeric display should read
EMPTY
HyperModel stored to your GNX3000.
6. Press the AMP SAVE button again to save to this Amp location. The display
briefly reads AMP SaVeD
selected preset.

Select Models for the Preset's Channels

In the previous steps, we selected a Tweed amp model for the Channel 1 amp and a
Rectified amp model for the Channel 2 amp. Then we warped the two together to
create our HyperModel TM
Rectwed, but it is not currently part of our preset. In this example preset, we need to
be able to toggle between an acoustic guitar simulation and our new HyperModel. To
do this we need to now select the Dreadnaught acoustic guitar model for Channel 1's
amp and our custom Rectwed for Channel 2's amp in our preset. This procedure is as
follows:
1. Press the GENETX Amp Control button.
2. Rotate KNOB 1 until the display reads
for the preset.
3. Rotate KNOB 4 until the display reads
This is Channel 2's Model for the preset. This lets us toggle between these two
sounds using the Amp Footswitch (when Preset Mode is active).
2. Rotate the Knob 1
until Display reads
ac dread
86
(Amp Saved) and then returns to the name of the
u1
empty
5. Use the Data Wheel
to select an empty
User Amp location
. This HyperModel is saved as an amp type that we named
AC dread
RECTWeD
3. Rotate Knob 4
until Display reads
rectwed
if this is the first
U1
6. Press the Amp
Save button
. This is Channel 1's Model
(our new HyperModel).